Automotive Engineering Centre supports and coordinates all services needed by customers on testing and R&D automotive components.  Its responsibilities are to provide and coordinate the use of all facilities in SIRIM and private facilities for automotive components and parts.  Tests carried out conform to national and international standards, manufacturer's specifications and legislative requirements.  The services offered on the automotive components and parts will conform to standards prescriptions, quality control testing, safety testing, and product quality certification, investigation testing and failure analysis.

 

Advantages at a glance : 

  • Acts as a focal point for automative components development and testing
  • Coordinates and leads development and acquires technology
  • Technical Services Provider which supports National Vehicle Type Approval (NVTA)


Offered Services :

Virtual Engineering and Simulation 
    • 3D Component Development for development testing
    • Structure Analysis and Dynamic Analysis
    • Body-Parts Dynamic Analysis
    • Fatigue Test
    • Static and Dynamic Test

New Services at AEC:

  • R66 – Bus Roll-over Test 
  • Design & CAE Work
  • NGV Test
  • Electrical Motocycle Test 
  • Photometric Test


For details, please contact : 

AUTOMOTIVE ENGINEERING CENTRE 

Lot 13,
Jalan Pahat 16/8A,
Section 16,
40000 Shah Alam,
Selangor Darul Ehsan.
03 – 5510 2175 (Office)
03 – 5510 2369 (Fax)

 

ZULKIFLI ZAHARI
General Manager
Automotive Engineering CentreThis email address is being protected from spambots. You need JavaScript enabled to view it.">
This email address is being protected from spambots. You need JavaScript enabled to view it.

03 – 5510 2175 (136)
019 – 262 3014